• Follow us
Home > News > Content
LED Street Light Design
Jun 16, 2017

LED lights and conventional street lamps is different, LED light source with low voltage DC power supply, by the GaN-based power-type blue LED and yellow synthesis of high efficiency white, with high efficiency, safety, energy saving, environmental protection, long life, fast response, high color rendering index Unique advantages can be widely used in roads. High temperature of 135 degrees, LED Street Light low temperature -45 degrees. LED street lamp design has the following requirements:

1, the biggest feature of LED lighting with directional light emission function, because the power LED is almost always equipped with reflectors, and the efficiency of this reflector are significantly higher than the lamp reflector efficiency.

In addition, LED light efficiency detection has been included in the efficiency of its own reflector.

LED road lighting should be used as far as possible the use of LED directional light emission characteristics, so that the road lamps in the LED were directly directed to the light through the various areas of the road, and then use the lamp reflector auxiliary light, to achieve Very reasonable road lighting integrated light distribution.

It should be said that the road lamps to be truly in line with CJJ45-2006 and CIE31 and CIE115 standard illumination and illumination uniformity requirements, LED Street Light the lamp should contain three times the function of light distribution can be better achieved. And with a reflector and has a reasonable beam output angle of the LED itself has a good light distribution function.

In the lamp, according to the height of the road lighting and the width of the road design of the LED installation location and the direction of the launch light can achieve a good secondary light distribution function. Reflectors in such lamps, only as auxiliary three light distribution means, to ensure greater uniformity of road illumination.

In the actual design of the road lighting, you can use the basic set in the direction of each LED set under the premise of each LED with a spherical universal joint fixed on the lamp, when the lamps used in different height and irradiation width , Can be adjusted by the spherical universal joint so that the direction of each LED to achieve satisfactory results.

In determining the power of each LED, the beam output angle, LED Street Light according to E (lx) = I (cd) / D (m) 2 (light intensity and illumination distance square inverse law), respectively, the LED in the basic selection The beam output angle should have the power, and can be adjusted by the LED power and LED driver circuit output to each LED different power to make each LED light output to achieve the expected value.

How to make a tightly packed together a group of LED security, LED Street Light but also an indicator of LED lights. LED on the drive circuit requirements is to ensure that the characteristics of constant current output, because the LED forward work when the junction voltage relative to the region is very small, so to ensure that the LED drive current is also a constant guarantee of LED output power is constant.

For China's power supply voltage supply instability of the status quo, LED Street Light road lighting LED drive circuit with constant current output characteristics is necessary to ensure that the light output is constant and to prevent the LED super power operation.

The following are the same as the "

To make the LED drive circuit exhibits constant current characteristics, from the output of the drive circuit inward view, the output impedance must be high.

Work, the load current is also through the output impedance, LED Street Light if the drive circuit by the buck, rectifier filter after adding DC constant current source circuit or a common switching power supply and resistance circuit, on which must also consume a lot of active Power, so these two types of drive circuit in the basic to meet the premise of constant current output, the efficiency is not high.